Sélection du chalut pélagique Isaacs-Kidd 10 pieds

This paper deals with the selection of the 10-foot Isaacs-Kidd midwater trawl, 4 mm in mesh size, which terminates in a fine-mesh section of 1 mm mesh aperture. It is emphasized that this finer mesh adds a large fraction of small animals to the main catch, This fraction has been estimated from comparisons between catches collected (1) with the above gear, (2) with the above gear terminating in a 4 mm mesh cod-end, (3) with the 1 mm mesh cod-end used alone as a net. It is demonstrated that escape through 4 mm meshes is a function both of hauling duration and of vertical distribution of organisms. The experimental part of this work has been carried out on crustaceans.     

Flow Dynamics in Eccentrically Rotating Flasks Used for Dispersant Effectiveness Testing

The evaluation of dispersant effectiveness used for oil spills is commonly done using tests conducted in laboratory flasks. We used a Hot Wire Anemometer (HWA) to characterize mixing dynamics in the Swirling Flask (SF) and the Baffled Flask (BF), the latter is being considered by the EPA to replace the prior to test dispersant effectiveness in the laboratory. Five rotation speeds of the orbital shaker carrying the flasks were considered, Ω = 50, 100, 150, 175 and 200 rpm. The radial and azimuthal water speeds were measured for each Ω. It was found that the flow in the SF is, in general, two-dimensional changing from horizontal at low Ω to axi-symmetric at high Ω. The flow in the BF appeared to be three-dimensional at all rotation speeds. This indicates that the BF is more suitable for representing the (inherently) 3-D flow at sea. In the SF, the speeds and energy dissipation rates ɛ increased gradually as the rotation speed increased. Those in the BF increased sharply at rotation speeds greater than 150 rpm. At 200 rpm, the Kolmogorov scale (i.e., size of smallest eddies) was about 250 and 50 μm in the SF and BF, respectively. Noting that the observed droplet sizes of dispersed oils range from 50 to 400 μm (hence most of it is less than 250 μm), one concludes that the mixing in the SF (even at 200 rpm) is not representative of the vigorous mixing occurring at sea.     

Choosing rewarding flowers; perceptual limitations and innate preferences influence decision making in bumblebees and honeybees

Flowers exhibit great intra-specific variation in the rewards they offer. At any one time, a significant proportion of flowers often contain little or no reward. Hence, foraging profitably for floral rewards is problematic and any ability to discriminate between flowers and avoid those that are less rewarding will confer great advantages. In this study, we examine discrimination by foraging bees among flowers of nasturtium, Tropaeolum majus. Bee visitors included carpenter bees, Xylocopa violacea, which were primary nectar robbers; honeybees, Apis mellifera, which either acted as secondary nectar robbers or gathered pollen legitimately and bumblebees, Bombus hortorum, which were the only bees able to gather nectar legitimately. Many flowers were damaged by phytophagous insects. Nectar volume was markedly lower in flowers with damaged petals (which were also likely to be older) and in flowers that had nectar-robbing holes. We test whether bees exhibit selectivity with regards to the individual flowers, which they approach and enter, and whether this selectivity enhances foraging efficiency. The flowers approached (within 2 cm) by A. mellifera and B. hortorum were non-random when compared to the floral population; both species selectively approached un-blemished flowers. They both approached more yellow flowers than would be expected by chance, presumably a reflection of innate colour preferences, for nectar standing crop did not vary according to flower colour. Bees were also more likely to accept (land on) un-blemished flowers. A. mellifera gathering nectar exhibited selectivity with regards to the presence of robbing holes, being more likely to land on robbed flowers (they are not able to feed on un-robbed flowers). That they frequently approached un-robbed flowers suggests that they are not able to detect robbing holes at long-range, so that foraging efficiency may be limited by visual acuity. Nevertheless, by using a combination of long-range and short-range selectivity, nectar-gathering A. mellifera and B. hortorum greatly increased the average reward from the flowers on which they landed (by 68% and 48%, respectively) compared to the average standing crop in the flower population. Overall, our results demonstrate that bees use obvious floral cues (colour and petal blemishes) at long-range, but can switch to using more subtle cues (robbing holes) at close range. They also make many mistakes and some cues used do not correlate with floral rewards.     

Sorption of Isoproturon and Dimetomorph on lignocellulose from wheat

The adsorption of toxic chemicals on solid substates is a potential means to clean polluted waters. Here, the adsorption of two pesticides, isoproturon and dimetomorph, on lignocellulose extracted from wheat straw is investigated at 20 °C using batch adsorption experiments. Here, we show that the sorption of both pesticides is independent of pH. The sorption capacity of lignocellulose is evaluated. We show that the presence of metallic cations has no influence on the retention capacity of lignocellulose towards pesticides.     

Transport of particulate material and dissolved tracer in a highly permeable porous medium: comparison of the transfer parameters

We are experimentally studying, by means of short-pulse injection, the transport and deposition kinetics of suspended particles (silts of the order of 10 microm) in a highly permeable medium consisting of a column of gravel. In our experiments, the breakthrough curves (BTCs) are well described by analytical solutions of a convection/dispersion model with first-order deposition kinetics. All the transport parameters calculated by the model for both particles and dissolved tracer depend on the flow rate. We demonstrate the existence of a critical flow rate, determined experimentally, beyond which the transfer time for the particles is longer than that for the tracer. This phenomenon is unusual in comparison with the results available in the literature. The increase in transfer time of particles in comparison to tracer leads us to assume a purely mechanical phenomenon, that is, collision between particles and grains of the medium with instantaneous reset in motion when the flow rate is sufficient to avoid settling. Thanks to the polydispersivity of the injected suspension and the control of grain size at the outlet, it can also be determined that the coarser particles are recovered before the finer particles, as expected when one considers the size-exclusion effect.     

Use of the aquatic lichen Dermatocarpon luridum as bioindicator of copper pollution: accumulation and cellular distribution tests

Laboratory experiments were conducted to investigate the potential use of the aquatic lichen Dermatocarpon luridum as bioindicator of copper pollution. Lichen thalli were exposed to 0.00, 0.25, 0.50, 0.75 and 1.00 mM copper in synthetic freshwater to solve the problems of metal bioavailability. The mineral composition of this media was prepared so that it corresponded to the ion composition of natural waters in D. luridum ecosystems. Sequential elution procedures using NiCl2 or Na2-EDTA (20 mM) were used to determine the distribution of metals at different cellular sites. The copper concentration extracted from thalli was correlated with pollution intensity, the greater correlation being with the Na2-EDTA extractant. The malondialdehyde concentration in thalli can be used as indicator of copper pollution; however, similar membrane degradation was observed for 0.25 and 0.50 mM copper and for 0.75 and 1.00 mM copper.     

Exploiting plant metabolism for the phytoremediation of persistent herbicides

Weed control by herbicides has helped us to create the green revolution and to provide food for at least the majority of human beings living today. However, some herbicides remain in the environment and pose an ecological problem. The present review describes the properties and fate of four representative herbicides known to be presistent in ecosystems. Metabolic networks are depicted and it is concluded that removal of these compounds by the ecologically friendly technique of phytoremediation is possible. The largest problem is seen in the uptake of the compounds into suitable plants and the time needed for such an approach.     

Debromination of hexabromobenzene by its co-grinding with CaO

A hexabromobenzene (HBB, C6Br6) powder was subjected to co-grinding with excess CaO powder in air using a planetary ball mill to investigate mechanochemical debromination of the HBB sample. The reaction proceeds smoothly with an increase in both grinding time and molar ratio of CaO addition. The co-grinding enables us to debrominate HBB, forming CaBr2, C and CaCO3 besides excess CaO in the product. CaBr2 in the product tends to absorb moisture from the atmosphere to form CaBr2 x nH2O. The reaction yield is quantitatively evaluated by measuring the amount of water-soluble bromide through water washing and the amount of unreacted HBB through toluene washing. It is found that almost 100% of debromination is achieved by 6 h grinding with the molar ratio kept constant at 2:1. Radicals are detected in the ground products, possibly due to rupture in the covalent bonds of C-C and C-Br in HBB.